X Series E53 X5 4.8is (N62-S) OFFRD
Release screws between cylinder head and timing case cover.
Note:
At narrow points, use a socket with 3/8" drive and a short
extension.
Release cylinder-head bolts in sequence 10 ... 1.
Lift off cylinder head.
Lift off cylinder head gasket.
Installation:
Installation of cylinder head is described separately from removal.
Clean sealing faces of cylinder head and crankcase; if necessary,
remove gasket debris with wooden scraper. Make sure no gasket
debris drops into the oil and coolant ducts.
Threaded bores in engine block must be free of dirt and oil (risk of
cracking).
Coat joint between engine block and timing case cover with
Drei Bond 1209 (refer to BMW Parts Service).
RA Removing and installing left cylinder head (N62 from 9/03 and N62TU)
BMW AG - TIS
12.02.2013 03:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
