X Series E53 X5 4.8is (N62-S) OFFRD
Important!
The lower section of the bearing bracket (1) is machined with
the cylinder head and must not be mixed up.
Note:
Lower section of bearing bracket (1) remains on cylinder head.
Important!
Rockers arms (1) are divided into individual tolerance
classes.
The tolerance classes are designated as illustrated with the
numbers from 1 to 4.
Used rocker arms (1) may only be reused in the same
position.
When replacing rocker arms (1) on inlet side: install rocker arms
of the same tolerance class in the same position.
Remove rocker arms (1) on inlet side and set aside in neat order.
Installation
Installation of rocker arms is described separately from removal.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
Ends of compression rings (1) point upwards.
Make sure compression rings (1) are engaged at ends.
RA Removing and installing/replacing rocker arms on left inlet side (N62 to 9/03)
BMW AG - TIS
12.02.2013 04:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
