X Series E53 X5 4.8is (N62-S) OFFRD
37 14 515
Replacing (removing and installing) rear left
or right ride-height sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
After installation:
•
Check headlight adjustment, correct if necessary
•
Version with ride-height control: Carry out ride-height-
calibration
•
Initialize Run Flat Indicator
Disconnect plug connection (1).
Release nut (2) and disconnect jointed rod.
Tightening torque 37 14 7AZ
.
Release nut (3) and remove ride-height sensor with bracket.
Installation:
Align bracket by way of bore to centering pin (5) of threaded
plate.
Replace self-locking nut.
Tightening torque 37 14 11AZ
.
Replacement only:
Release screws and remove ride-height sensor from bracket.
Installation:
Ride-height sensor must be aligned to bracket so that sensor
lever (4) points outwards after ride-height sensor has been
installed.
Tightening torque 37 14 6AZ
.
After installation:
-
If necessary, bend bracket towards rear by
A = 3 to 4 mm to avoid a collision between eccentric bolt
and connection joining jointed rod to sensor lever
RA Replacing (removing and installing) rear left or right ride-height sensor
BMW AG - TIS
12.02.2013 09:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
