X Series E53 X5 4.8is (N62-S) OFFRD
37 14 519
Removing and installing/replacing pressure
sensor for air suspension (two-axle ride-
height control)
Warning!
Danger of injury!
Drain the air spring system before carrying out any work on
the air supply unit, air pipes and air springs! Danger of injury if
this instruction is not complied with!
Risk of damage!
The vehicle must not stand on its wheels when the air spring
struts and air springs are depressurized! Otherwise the air
spring struts and air springs will be damaged and later
destroyed during driving!
Extreme cleanliness must be ensured in the connection area
of the pipes during removal and installation. Even the smallest
of dirt particles can cause leakage in the air spring system.
Note:
Read and comply with notes on air spring system.
Necessary preliminary tasks:
•
Venting pressure accumulator:
-
Raise vehicle on lifting platform.
-
Connect BMW diagnosis system
-
Switch ignition on.
-
Vent pressure accumulator using the BMW diagnosis
system (control unit functions -> component activation:
activate menu item "Vent pressure accumulator" once)
•
Deactivating air spring system:
-
Remove ignition key
-
Pull fuse for control unit
•
Remove right underbody panelling
Important!
Risk of damage!
Do not kink, twist or crush pipes.
RA Removing and installing/replacing pressure sensor for air suspension (two-axle r
BMW AG - TIS
12.02.2013 09:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
