X Series E70 X5 3.0Sd (M57T2) OFFRD
Important!
Risk of damage!
First adjust minimum distance (A) = 3 mm between
control line (1) and oscillating motor (2).
Then adjust control line (3) with minimum
distance (B) = 8 mm to control line (1).
Mark installation position of control lines to oscillating motor.
Release banjo nuts (1) and remove control lines (2) from
oscillating motor.
Seal control lines (2) and connections of oscillating motor with
sealing plugs.
Installation:
Control lines are protected against being mixed up by different
thread diameters on the oscillating motor connection.
Tightening torque 37 14 18AZ
.
Release spring-type actuator (1) with special tool 37 1 160 ;
turn stabilizer leg if necessary.
Tightening torque 37 14 23AZ
.
Installation:
Remove protective cap.
Fit O-ring (1) only in dry condition.
RA Replacing spring-type actuator for active stabilizer at front
BMW AG - TIS
05.02.2013 09:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -