X Series E70 X5 4.8i (N62TU) OFFRD
Attach support pot (1) and protective tube (2) to piston rod.
Left spring strut only:
Important!
Stud (1) above opening (2) must point in direction of
travel (F)!
Coding (3) of spring pad must be seated in opening (2)
opposite stud (1)!
Version with Vertical Dynamics Management:
Stud (4) must be flush with positioning pin (5)!
Right spring strut only:
Important!
Stud (1) above opening (2) must point in direction of
travel (F)!
Coding (3) of spring pad must be seated in opening (2)
below stud (1)!
Version with Vertical Dynamics Management:
Stud (4) must be flush with positioning pin (5)!
Attach support bearing flange (1) to piston rod.
Align support bearing upper section (3) as illustrated and attach
to inner section (2) of support bearing flange (1).
Note:
Pay attention to edge (4) in shown in illustration.
RA Replacing front left or right spring strut shock absorber
BMW AG - TIS
08.02.2013 02:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
