X Series E70 X5 4.8i (N62TU) OFFRD
Attach joint disc (1) to piston rod.
Replace nut (2) and tighten down (gripping piston rod in so
doing).
Tightening torque 31 31 2AZ
.
Important!
Align support bearing flange (1) and shock absorber (3) by
means of spring pads to coil spring ends.
Relieve tension on coil spring.
Check installation position of protective tube (2), correct if
necessary.
After fitting on version with Vertical Dynamics Management:
•
Code spring strut with DIS Tester and check software status
•
Carry out vertical acceleration sensor adjustment
RA Replacing front left or right spring strut shock absorber
BMW AG - TIS
08.02.2013 02:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
