bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

11 RA Removing And Installing_replacing Power Steering Pump For Power Steering Gear Wi|Page 1155 > < 10 RA Removing And Installing Power Steering Pump For Power Steering Gear With Active |Page 1153
Page 1
background image

32 41 037

Removing and installing/replacing power
steering pump for power steering gear with
Dynamic Drive (N62, N62TU)

Warning!

Danger to life!

Mount securing fixture for vehicle on lifting platform to prevent
the vehicle from slipping off or tilting down.

Secure engine in installation position to prevent it from falling
down.

Warning!

Danger of poisoning if oil is ingested/absorbed through the
skin!

Risk of injury if oil comes into contact with eyes and skin!

 

Important!

Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.

Seal off hydraulic lines with plugs.

Note:

When replacing power steering pump:

Fluid reservoir must be replaced in event of metal abrasion,
sluggish pump shaft or increased wear!

The filter integrated in the fluid reservoir can only absorb a limited
amount of foreign particles. If the filter clogs, the hydraulic system
can no longer be sufficiently protected.

Metal abrasion is perceived in the fluid reservoir as metallically
glittering hydraulic fluid.

It is only necessary to replace the fluid reservoir because of leaks
(e.g. at hose connections) only in the event of the unavoidably
high ingress of dirt.

RA  Removing and installing/replacing power steering pump for power steering gear wi

BMW AG - TIS

08.02.2013  03:52

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

11 RA Removing And Installing_replacing Power Steering Pump For Power Steering Gear Wi|Page 1155 > < 10 RA Removing And Installing Power Steering Pump For Power Steering Gear With Active |Page 1153