X Series E70 X5 4.8i (N62TU) OFFRD
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove belt pulley
•
Lower front axle carrier
Version with active front steering: Disconnect plug
connection (1).
Release hose clamp (4) and detach suction line from power
steering pump.
Release banjo bolt (3) and disconnect pressure line for power
steering from power steering pump.
Release banjo bolt (2) and detach pressure line
for Dynamic Drive from power steering pump.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Align suction line by way of marking to connection on power
steering pump.
Tightening torque 32 41 4AZ
(for power steering).
Tightening torque 32 41 10AZ
(for Dynamic Drive).
Release screws (1) and remove holder (2) and power steering
pump towards bottom.
Tightening torque 32 41 3AZ
.
RA Removing and installing/replacing power steering pump for power steering gear wi
BMW AG - TIS
08.02.2013 03:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -