X Series E70 X5 4.8i (N62TU) OFFRD
2
Plug connection for pulse generator
Release retainer (1) and remove brake hose (2) from shock
absorber (4).
Installation:
When installing the shock absorber, ensure that the holder for the
brake hose (2) points to the middle of the vehicle.
Ensure correct seating in guide.
Retainer must be felt and heard to snap into place.
Release screw (3).
Important!
Secure shock absorber against falling out.
Remove shock absorber (4) from swinging arm and tie back.
Important!
Before tightening screw/bolt connection, check that shock
absorber pin is correctly positioned in swinging arm.
Screw must not be used as an aid to installing the shock
absorber!
Installation:
Replace screw.
Tighten bolt in normal position.
Tightening torque 33 52 3AZ
.
Important!
Risk of damage!
Do not pull expanding clips with luggage compartment tray out
of lashing rail.
Release expanding clips (1).
Press luggage compartment tray (2) to one side.
Installation:
Replace damaged expanding clips.
RA Removing and installing/replacing rear left or right shock absorber
BMW AG - TIS
08.02.2013 04:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
