X Series E70 X5 4.8i (N62TU) OFFRD
34 31 181
Removing and installing / replacing
expansion tank for hydraulic brake actuation
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove left microfilter housing cover
Note:
Extract brake fluid out of expansion tank. Use a suction bottle
used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.
Unfasten plug connection (1) and disconnect.
Remove wiring harness from holder (2).
Release screw (3) and lift off expansion tank.
Important!
Check rubber plug in brake master cylinder for damage and
replace if necessary.
Push the expansion tank vertically onto the master brake
cylinder.
RA Removing and installing / replacing expansion tank for hydraulic brake actuation
BMW AG - TIS
08.02.2013 05:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
