X Series E70 X5 4.8i (N62TU) OFFRD
61 71 061
Replacing (removing and installing) fluid
reservoir for windscreen washer unit
Necessary preliminary tasks:
•
Remove trim panel for cover on frame side member on right
•
Remove wheel arch trim at front right
•
Remove auxiliary direction indicator light at front right
Release screw (1).
Twist filler duct (2) in direction of arrow out of fluid reservoir
for windscreen washer unit (3) and remove.
If necessary, release air supply unit vent line (4) at mounting
points (5) from fluid reservoir for windscreen washer unit (3).
Release screws.
Press off side panel slightly.
Installation:
Tightening torque 41 35 7AZ
(A-pillar area).
Tightening torque 41 35 8AZ
(sill area).
Note:
Side panel shown removed for purposes of clarity.
Catch any escaping washer fluid if necessary.
Remove washer pump of headlight washer system (1) .
Remove washer pump for rear window washer system (2) .
Disconnect plug connection (3) and unclip wiring harness.
Remove windscreen washer pump (4) .
Remove level switch for windscreen washer unit (5) .
RA Replacing (removing and installing) fluid reservoir for windscreen washer unit
BMW AG - TIS
08.02.2013 14:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
