X Series E83 X3 2.0d (N47) OFFRD
25 11 245
Replacing shift arm support bearing
Necessary preliminary tasks:
•
Remove complete exhaust system.
•
Remove heat shield
-
Remove propeller shaft from transfer box at rear.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Lever support bearing (1) with a short screwdriver out of
mounting.
Pull support off shift arm.
Installation:
Grease bearing pin of shift arm.
Grease, refer to BMW Service Operating Fluids.
Fit support bearing (1) with opening (2) towards top rear
onto mounting.
RA Replacing shift arm support bearing
BMW AG - TIS
05.02.2013 23:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -