X Series E83 X3 3.0d (M57TU) OFFRD
Warning!
Danger to life!
Car may tilt off lifting platform if the workshop jack is
incorrectly handled.
After supporting components, make sure that:
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Remove compression strut and insert bolts for rear axle carrier at
front until contact is made.
Support rear differential with workshop jack and special tool
33 4 420 .
Important!
Observe gap between special tool 33 4 420 and dust
plates (1).
To avoid grinding noises, make sure the dust plates (1) are
not damaged (e.g. bent).
Release screws (1).
Unfasten nut.
Unscrew bolt to centre of car; if necessary, remove spacer.
Slowly lower workshop jack and tip rear differential out towards
rear.
RA Removing and installing/replacing rear differential
BMW AG - TIS
15.02.2013 01:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -