Z Series E86 Z4 3.0Si (N52) COUPE
51 14 010
Removing and installing/replacing rear BMW
badge
Special tools required:
•
00 9 322
Important!
The Instructions on component cementing with double-sided
adhesive tape serve as the basis for this repair instruction and
must be observed without fail.
Heat BMW badge (1) with hot air blower and lever out with
special tool 00 9 322 .
Installation:
Pull liner* off adhesive tape (1).
Position badge over guides (2 and 3) and press down firmly.
* Liner is the protective film on a new badge.
RA Removing and installing/replacing rear BMW badge
BMW AG - TIS
08.02.2013 13:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
