Century V6-3100 3.1L VIN M SFI (1998)
6. Pull the connection apart.
7. Use a clean shop towel in order to wipe off the male fuel pipe end.
8. Inspect both ends of the quick-connect fitting for dirt and burrs.
9. Clean or replace components/assemblies as required.
INSTALLATION PROCEDURE
WARNING: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean
engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located In the female connector will swell and may prevent proper reconnection if not lubricated.
NOTICE: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.
Do not repair sections of fuel pipes.
1. Apply a few drops of clean engine oil to the male fuel pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/lingers to snap into place.
3. Pull on both sides of the quick-connect fitting in order to make sure the connection is secure, once installed.
4. Install the retainer on to the quick-connect fitting if applicable.