LaCrosse V6-3.6L VIN 7 (2006)
Control Arm Bushing: Service and Repair
Lower Control Arm Bushings Replacement (Vertical)
Lower Control Arm Bushings Replacement (Vertical)
^
Tools Required
-
J 21474-01 Control Arm Bushing Set
-
J 21474-271/2 Inch Puller Bolt Thrust Bearing
-
J 21474-2Bushing Installer Remover
-
J 21474-4Nut
-
J 21474-13 Control Arm Bushing Installer
-
J 23444-A High Pressure Lubricant
-
J 34126 Driven Sprocket Support Bearing Installer
-
J 35379 Front Knuckle Support
Removal Procedure
1. Remove the lower control arm. Refer to Lower Control Arm Replacement.
2. Secure the lower control arm in a vice.
3. Mark the lower control arm along the flat edge of the bushing flange.
4. Important: Apply J 23444-A or equivalent to the threads of J 21474-27.
Assemble the following bushing removal tools as shown:
1. J 21474-27
2. J 21474-13
3. J 34126
4. J 35379
5. J 21474-2
6. J 21474-4
5. Tighten J 21474-4.
6. Disassemble the bushing removal tools.