LaCrosse V6-3.8L (2009)
Control Module HVAC: Service and Repair
Blower Motor Control Module Replacement
Blower Motor Control Module Replacement
Removal Procedure
1. Remove the right side instrument panel (I/P) insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side (See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair).
2. Disconnect the electrical connector from the blower control module.
3. Remove the 2 heat stakes from the blower control module using a small chisel.
4. Remove the blower control module.
Installation Procedure
1. Install the blower control module.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 2 new screws in the pre-drilled holes to the side of the heat stakes in the blower control module and the HVAC module assembly.
Tighten the screws to 1.5 Nm (13 lb in).