Park Avenue V6-3.8L SC VIN 1 (2005)
11. With the compressor mounted to the J 34992 , position the rotor and bearing assembly on the front head.
12. Position the J 33017 and the J 33023-A directly over the inner race of the bearing.
13. Position the J 8433-1 on the J 33023-A.
14. Assemble the 2 through bolts and the washers of the J 34992 through the slots of the J 8433-1.
15. Thread the 2 through bolts into the J 34992.Ensure that the thread of the through bolts engages the full thickness of the J 34992.
16. Tighten the J 8433-3 in the J 8433-1 in order to force the pulley rotor and bearing assembly onto the front head of the compressor.
17. If the J 33017 slips off direct, in-line contact with inner face of the bearing, use the following steps:
1. Loosen the J 8433-3.
2. Realign the J 33017 and the J 33023-A in order to ensure that the installer clears the front head.
18. Install the rotor and bearing assembly retainer ring using the J 6083.
19. Install the clutch plate and hub assembly.
20. Install the shaft nut.
