Regal V6-191 3.1L VIN M SFI (1995)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Modulator Assembly Removal and Instalation
HYDRAULIC MODULATOR-MASTER CYLINDER ASSEMBLY
CAUTION:To help avoid personal injury, due to a retained load on the hydraulic modulator, the gear tension relief function of the Tech 1 must
be performed prior to removal of the ABS hydraulic modulator/master cylinder assembly.
Remove or Disconnect
1. Using Tech 1, perform "Gear Tension Relief Sequence".
2. Two solenoid electrical connectors.
3. Fluid level sensor electrical connector.
4. 6-way ABS motor pack electrical connector.
5. Four brakes pipes.
6. Two nuts attaching ABS hydraulic modulator/master cylinder assembly to vacuum booster.
7. ABS hydraulic modulator/master cylinder assembly.
Install or Connect
1. ABS hydraulic modulator/master cylinder assembly in vehicle.
2. Two nuts attaching ABS hydraulic modulator/master cylinder assembly to vacuum booster
Tighten
^
Nuts to 27 N.m (20 lb. ft.).
3. Four brake pipes to ABS hydraulic modulator/master cylinder assembly.
4. ABS motor pack 6-way electrical connector.
5. Fluid level sensor electrical connector.
6. Two solenoid electrical connectors.
Important
7. Bleed hydraulic system.
Tighten
^
Tube nuts to 24 N.m (18 lb. ft.).