Regal V6-191 3.1L VIN M SFI (1995)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Modulator Solenoid Assembly
ABS HYDRAULIC MODULATOR SOLENOID
Hydraulic Modulator Solenoid Assembly
1. Remove solenoid electrical connector.
2. Remove Torx® head bolts.
3. Remove solenoid.
Important
^
Be sure the seal is still attached to the solenoid when it is removed. If not, check solenoid bore in modulator.
^
Do not attempt to disassemble solenoid, it is serviceable only as an assembly. Lubricate seal on new solenoid with clean brake fluid.
^
Verify that the solenoid lip seal is properly positioned before solenoid is installed in Hydraulic Modulator.
^
Position solenoid so that its electrical connector will face the same direction as the solenoid that was removed.
^
By hand, press down firmly solenoid until its flange seats on the hydraulic modulator.
4. Reinstall Torx head bolts.
Tighten
^
Bolts to 4.5 N.m. (40 lb. in.).
5. Reinstall solenoid electrical connector to solenoid.
Important