Rendezvous FWD V6-3.5L VIN L (2006)
3. Rotate the engine for access to the rear of the engine. Refer to Rotating the Engine for Service Access.
4. Remove the spark plug wire(s) (1, 3, and/or 5) from the right side spark plug(s).
5. Remove the spark plug(s) from the cylinder head.
INSTALLATION PROCEDURE
1. Gap the spark plugs to specifications. Refer to Ignition System Specifications.
NOTE: It is important to check the gap of all new and reconditioned spark plugs before installation. Pre-set gaps may have changed during handling.
Use a round wire feeler gauge to be sure of an accurate check, particularly on used plugs. Installing plugs with the wrong gap can cause poor engine
performance and may even damage the engine.
2. Install the spark plug(s) to the cylinder head.
NOTE: Be sure plug threads smoothly into cylinder head and is fully seated. Use a thread chaser if necessary to clean threads in cylinder head.
Cross-threading or failing to fully seat spark plug can cause overheating of plug, exhaust blow-by, or thread damage. Follow the recommended torque
