Riviera V6-231 3.8L VIN C SFI (1989)
11.
Trim urethane dispense tip as shown in Figure 4, View A.
12.
Apply urethane bead to glass ensuring a bead size of 7 mm wide by 8-10 mm high.
13.
Position glass in opening onto spacers. With glass centered in opening, place glass on lower supports and use tape applied in Step 8 to carefully
place glass in proper position.
14.
Press glass firmly to set adhesive. Use care to avoid excessive squeeze out which may cause an appearance problem.
15.
Except where push-in molding will be inserted, paddle excess urethane around glass to ensure watertight seal. If necessary, paddle additional