Riviera V6-3.8L SC VIN 1 (1995)
Hard Top: Technical Service Bulletins
Cardboard Roof Insulator - R&R Procedure
File In Section: 10 - Body
Bulletin No.: 63-10-47
Date: December, 1996
SERVICE MANUAL UPDATE
Subject:
Section 10-9 - Removal/Installation Procedure for Cardboard Roof Insulator
Models:
1995-97 Buick Riviera
1997
Buick Park Avenue
1996
Cadillac Concours, DeVille, Eldorado, Seville
1995-97 Oldsmobile Aurora
This bulletin is being issued to add the cardboard roof insulator removal and installation procedure to Section 10-9 of the appropriate Service Manuals
for the above listed vehicles.
Cardboard Roof Insulator
Remove or Disconnect
1.
Headliner assembly. Refer to Section 10-9 of the Service Manual.
2.
Carefully separate headliner from cardboard roof insulator.
3.
Starting at one corner of cardboard, pulling downward, cut adhesive bead using a sharp putty knife or equivalent.
Notice:
^
Care should be taken not to damage roof panel when removing old adhesive.
^
When servicing vehicles with rear vanities, be sure to remove the rear vanities before dropping the headliner. Failure to remove rear vanities
will cause roof panel damage. Also, leave the black rear vanity retainer glued to the roof. If you must remove the retainer, be very careful or
damage to the roof panel may occur.
4.
Cut off all of the adhesive beads.
5.
Cardboard insulator.
Important:
It is not necessary to remove all of the old adhesive.
Install or Connect