Riviera V6-3.8L SC VIN 1 (1995)
5.
Cut off all of the old heat element harness (11) from the seat cushion trim cover.
Important:
Ensure the heat element is laying flat with no wrinkles on the seat cushion pad.
6.
Install the seat cushion cover. Refer to Seat Cushion Replacement - Front in the Seats sub-section of the Service Manual.
7.
Ensure the seat heat function is operational.
Seat Back Heat Element Replacement - Front
For 1995-1999 Aurora and Riviera
1.
Remove the seat back cover. Refer to Seat Back Cover and Pad Replacement - Front in the Seats sub-section of the Service Manual.
2.
Install the seat heat element (Aurora shown).
^
Remove the paper from the tape that is located on the back of the heat element.
^
Carefully position and press the heat element (1) onto the seat back cushion pad (2).
^
Tuck the narrow connecting strips into the seat back cushion pad trenches.
3.
Insert the seat heat element harness through a hole located in the right rear corner of the seat cushion trim cover and the seat cushion pad.
4.
Connect the seat heat element GREEN electrical connector to the Heat Module GREEN electrical connector.
