Skylark V6-3100 3.1L VIN M SFI (1996)
When ignition switch control is desired, and no SEO wiring exists, a 12 volt power contactor must be installed in the transceiver positive power
lead (See Figure 3 - Power Contactor Wiring).
The contactor (supplied by the installer) should be located near a proper 12 volt feed source.
One lead of the contactor coil should be connected through an appropriate in-line fuse to an available accessory circuit or ignition circuit not
powered during engine cranking.
The return lead of the contactor coil must return to a proper fused negative point.
c.
Handset or Control Units
1.
Any negative power lead from a handset or control unit must return to a properly fused negative connection point.
2.
It is preferable that the positive power lead for a handset, or control unit, be connected directly to a properly fused positive power feed point.
If ignition switch control is desired, the handset or control unit positive power lead may be connected through an appropriate in-line fuse to an
