Skylark V6-3100 3.1L VIN M SFI (1996)
Brake Shoe: Service and Repair
Fig. 1 Drum Brake Assembly. Type 1.
REMOVAL
1. Raise and support rear of vehicle, then remove tire and wheel assembly.
2. Remove brake drum. If brake lining is dragging on brake drum, back off brake adjustment by rotating. adjustment screw. Refer to individual car
chapter for procedure. If brake drum is rusted or corroded to axle flange and cannot be removed, lightly tap axle flange to drum mounting
surface with a suitable hammer.
3. Using brake spring pliers or equivalent, unhook primary and secondary return springs, Fig. 1. Observe location of brake parts being removed to
aid during installation.
4. Remove brake hold-down springs with suitable tool.
5. Lift actuating lever, then unhook actuating link from anchor pin and remove.
6. Remove actuating lever(s) and return spring.
7. Spread shoes apart and remove parking brake strut and spring.
8. Disconnect parking brake cable from lever, then remove brake shoes from backing plate.
9. Separate brake shoes by removing adjusting screw and spring, then unhook parking brake lever from shoe assembly.
10. Clean dirt from brake drum, backing plate and all other components. Do not use compressed air or dry brush to clean brake parts. Many
brake parts contain asbestos fibers which, if inhaled, can cause serious injury. Clean brake parts with a water soaked rag or a suitable
vacuum cleaner to minimize airborne dust.
INSTALLATION
1. Lubricate parking brake lever fulcrum with suitable brake lube, then attach lever to brake shoe. Ensure lever operates smoothly.
2. Connect brake shoes with adjusting screw spring, then position adjusting screw. Ensure adjusting screw star wheel does not contact adjusting
screw spring after installation and also ensure righthand thread adjusting screw is installed on left side of vehicle and lefthand thread adjusting
screw is installed on right side of vehicle. When brake shoe installation is completed, ensure starwheel lines up with adjusting hole in backing plate
