Skylark V6-3100 3.1L VIN M SFI (1996)
3. Remove the drive belt from the generator pulley.
4. Raise the vehicle. Support the vehicle.
5. Remove the right tire and wheel assembly.
6. Remove the right splash shield.
7. Remove the tensioner bolt.
8. Remove the tensioner.
Installation Procedure
Tools Required
J 39914 Drive Belt Tension Wrench
1. Install the drive belt tensioner.
2. Install the tensioner bolt.
Tighten
Tighten the bolt to 50 Nm (37 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
3. Install the right splash shield.
