Skylark V6-3100 3.1L VIN M SFI (1996)
Install the outer drive drum onto the mandrel (EN-481 08). Install the bearing, washer and the drive nut onto the threaded shaft. Refer to the above
illustration.
Using a wrench, turn the drive nut on the mandrel (EN-48108), which will push the seal into the engine block bore. Turn the wrench until the drive drum
is snug and flush against the engine block. Refer to the above illustration.
Loosen and remove the drive nut, washer, bearing and drive drum. Discard the protective nylon sleeve.
Verify that the seal has seated properly.
Use a flat-bladed screwdriver to remove the two attachment screws from the mandrel and remove the mandrel from the crankshaft hub. Refer to the
above illustration.
Install the engine flywheel. Refer to Engine Flywheel Replacement in SI or the appropriate Service Manual.
Install the transmission. Refer to Transmission Replacement in SI or the appropriate Service Manual.
Inspect for proper fluid levels.
Inspect for leaks.
Parts Information
