Skylark V6-3100 3.1L VIN M SFI (1996)
Timing Cover: Service and Repair
Replacement
TOOL REQUIRED
^
J 28467-360 Engine Support Fixture
REMOVAL
1. Disconnect the negative battery cable.
2. Drain the cooling system. See Cooling System.
3. Install the Engine Support Fixture.
4. Remove the engine mount assembly.
5. Remove the engine mount bracket support.
6. Remove the drive belt.
7. Remove the power steering pump. See Steering and Suspension.
8. Loosen the top two A/C compressor bolts.
9. Raise the vehicle. Support the vehicle.
10. Remove the right front tire and wheel assembly.
11. Remove the right front splash shield. See Body and Frame.
12. Remove the flywheel inspection cover.
13. Remove the crankshaft balancer.
14. Remove the drive belt tensioner.
15. Remove the engine mount strut.
16. Remove the right wheel speed sensor connector and the wire harness from the suspension support.
17. Remove the right ball joint. See Steering and Suspension.
18. Remove the right stabilizer shaft from the right suspension support and the right control arm.
19. Remove the right suspension support. See Steering and Suspension.
