Skylark V6-3100 3.1L VIN M SFI (1996)
Knock Sensor Module: Service and Repair
Knock Sensor Installation
Squeezing Knock Sensor Tabs
REMOVE OR DISCONNECT
1. Remove the PCM.
2. Remove the access cover from the PCM.
3. Carefully squeeze the latches on the KS Module and carefully remove the KS Module. Apply pressure in the direction as shown.
INSTALL OR CONNECT
1. Carefully insert the KS module into the socket.
2. Carefully press down on the KS Module until the latches catch.
3. Install the PCM access cover.
4. Install the PCM.
