Skylark V6-3100 3.1L VIN M SFI (1996)
Ball Joint: Testing and Inspection
Ball joints must be replaced if any looseness is detected in the joint or the ball joint seal is cut. To inspect the ball joints, raise the front of the vehicle
allowing the suspension to hang free. Grasp the tire at the top and bottom and move the top of tire in an in-and-out motion. Observe for any horizontal
movement of the steering knuckle relative to the front lower control arm. If the ball stud is disconnected from the steering knuckle and any looseness
is detected, or if the ball stud can be twisted in its socket using finger pressure, replace the ball joint. Ball stud tightness in the steering knuckle boss
should also be check when inspecting the ball joint. This my be done by shaking the wheel and feeling for movement of the stud end or castellated nut
at the knuckle boss. Checking the fastener torque at the castellated nut is an alternative method of inspecting for wear. A loose nut can indicate a bent
stud or an opened hole in the knuckle boss. Worn or damaged ball joints and knuckles must be replaced.
