Skylark V6-3100 3.1L VIN M SFI (1996)
REMOVAL
Remove or disconnect the following:
1. Nuts and bolt attaching top of strut assembly to body.
2. Raise vehicle and suitably support.
3. Place jack stands under front suspension support.
4. Lower vehicle slightly so the weight of the car rests on the jack stands and not the control arms.
5. Tire and wheel assembly.
CAUTION: Care must be exercised to prevent the drive axle joints from being over-extended. When either end of the shaft is disconnected,
over-extension of the joint could result in separation of internal components and possible joint failure. Failure to observe this can result in interior
joint or boot damage and possible joint failure.
