Skylark V6-3100 3.1L VIN M SFI (1996)
6. Remove cotter pin and nut, and separate tie rod end from strut assembly using J 24319-01.
7. Brake line bracket.
8. Scribe strut flange.
9. Bolts attaching strut to steering knuckle.
10. Strut assembly from vehicle.
NOTE: Steering knuckle must be supported to prevent axle joint over-extension.
11. Refer to "Disassemble/Assemble Strut."
INSTALLATION
Install or connect the following:
1. Strut into position and install three nuts connecting strut assembly to body.
2. Align steering knuckle with strut flange scribe mark and install bolts and nuts.
^
Tighten nuts to 180 Nm (133 ft. lbs.).
3. Tie rod end into strut assembly and install tie rod end bolt and cotter pin.
^
Tighten tie rod end bolt to 60 Nm (44 ft. lbs.).
4. Tighten nuts and bolt attaching top of strut assembly to body to specifications.
^
Nuts to 25 Nm (18 ft. lbs.).
^
Bolt to 25 Nm (18 ft. lbs.).
5. Brake line bracket.
6. If suspension contact hoist is used:
^
Slightly raise vehicle.
^
Remove jack stands from under suspension supports.
7. Tire and wheel assembly.
8. Check front wheel alignment.