Skylark V6-3100 3.1L VIN M SFI (1996)
Q: Why didn't the machine come with the adapters to hook up to the car?
A: The J 45096 was designed to use the previously released essential cooler line adapters for the J 35944-A. All adapters are listed on page 17 of the
Operation Manual and can be ordered from Kent-Moore at 1-800-345-2233.
Q: How do I connect the J 45096 to a Catera, Prizm or a Vibe?
A: These vehicles, along with many other models, only require barbed fittings to connect to the rubber cooler hose. These fittings are commercially
available and already found in many shops.
Q: Why didn't I receive an Operation Manual with the machine?
A: The Operation Manual was packaged in the upper portion of the shipping carton. If the shipping carton was lifted off the base without opening the
top of the carton, the Operation Manual could have been discarded with the carton. Replacement Operation Manual packages can be obtained from
Kent-Moore Customer Service at 1-800-345-2233.
Q: Why can't I re-use the transmission fluid I use for flushing?
A: The very fine metal and clutch material debris from the transmission failure in the ATF causes failures with the hall effect speed sensors that are used
to measure the flow rate. To avoid costly repairs, expensive filters, regular maintenance and problems caused by a partially restricted filter, the filter
was not included.
Q: What do I do if I need service on my machine?
A: Call Kent-Moore Customer Service at 1-800-345-2233. The J 45096 has a one-year warranty.
Q: Can I flush and flow engine oil coolers?
A: The engine oil cooler flow rates, the appropriate adapters and an acceptable procedure are currently under development.
Disclaimer
