Terraza FWD V6-3.5L VIN L (2006)
1. Install the evaporator outlet tube (8) to the inlet tube (5).
2. Install the evaporator inlet/outlet tube assembly.
3. Install the evaporator inlet/outlet tube clip to shock tower nut (6).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 5.5 N.m (49 lb in).
4. Install a NEW sealing washer to the condenser end of the evaporator inlet tube.
5. Remove the cap or tape from the condenser opening.
6. Install the evaporator inlet tube (5) to the condenser.
7. Install the evaporator inlet tube to condenser bolt (2).
Tighten the bolt to 16 N.m (12 lb ft).
8. Install the evaporator inlet/outlet tube bracket bolt (4).
Tighten the bolt to 27 N.m (20 lb ft).
9. Install the electrical connector (3) to bracket.