Allante V8-273 4.5L (1991)
Evaporator Core: Service and Repair
EVAPORATOR CORE
A/C Module/Evaporator Lines
REMOVE OR DISCONNECT
1. Cross-tower support brace (one bolt each side).
2. Upper intake manifold.
3. Power module.
A. Three module retaining screws
B. Two electrical connectors.
4. Evaporator line block fitting bolt, detach inlet and outlet lines from evaporator.
5. Wire harness tie strap near evaporator line fitting.
6. Blower motor.
7. Heat shield (two screws).
8. Six large evaporator module noise barrier cover screws.
9. Five small module noise barrier cover screws.
10. Three small barrier clips.
11. Plastic barrier cover and seal gasket.
12. Evaporator core retaining screw and evaporator from vehicle.
INSTALL OR CONNECT
1. Evaporator core to case, secure with one screw.
2. Plastic barrier cover and a new seal gasket. Secure cover with three clips and eleven screws.
