Catera V6-3.0L VIN R (1997)
Bulletin No.: 01-08-64-005
Date: March, 2001
TECHNICAL
Subject:
Noise From Door Hinge Area When Opening Door
(Install Reinforcement/Brackets)
Models:
1997-2000
Cadillac Catera
Built Prior to VIN Breakpoints YR176008
Condition
Some customers may comment on noise coming from the hinge area when opening the door.
Cause
The sheet metal around the check link attaching holes may be cracked.
Correction
Install reinforcement and brackets to the door inner panel using the following procedure:
1.
For additional information during this procedure, refer to the Doors sub-section of the Service Manual.
2.
Disable the SIR system.
3.
Remove the door panel trim extension.
4.
Remove the door lock knob.
5.
Remove the door switch assembly.
6.
Remove the tweeter speaker grill plate.
7.
Remove the door panel screws.
8.
Remove the OSRV mirror.
9.
Remove the speaker.
10.
Remove the door water deflector.
11.
Remove the side door impact sensor plate rivets and plate.
12.
Remove the front run channel bolts.
13.
Tape off the door and fender edges to prevent damage.
14.
Remove the door check link.
15.
Disconnect the pass through harness between the door and fender.
16.
Support the door for removal.