Catera V6-3.0L VIN R (1997)
3. Install the serpentine drive belt tensioner.
4. Install the serpentine drive belt tensioner bolts. Tighten the serpentine drive belt tensioner bolts to 40 Nm (30 ft. lbs.).
5. Install the power steering pump pulley.
6. Install the power steering pump pulley bolts.
7. Snug the power steering pump pulley bolts. The bolts will be tightened to proper specification when the serpentine drive belt is installed.
8. Install the water pump pulley.
9. Install the water pump pulley bolts. Snug the water pump pulley bolts. The bolts will be tightened to proper specification when the serpentine drive
belt is installed.
10. Install the water pump pulley screws.
11. Route the wiring harness into the wiring harness channel.
12. Install the wiring harness channel cover.
13. Install the wiring harness channel extension to the right lower side of the wiring harness channel.
14. Install the serpentine drive belt.
15. Install the A/C compressor hose support strap bolt to the AIR injection crossover bracket.
-
Tighten the A/C compressor hose support strap bolt to 8 Nm (71 inch lbs.).
-
Tighten the water pump pulley bolts to 8 Nm (71 inch lbs.).
-
Tighten the power steering pump pulley bolts to 20 Nm (15 ft. lbs.).
16. Install the AIR injection diverter (8) hose connections.
17. Install the AIR injection diverter hose clamps.
18. Install the AIR injection crossover pipe bushing nut (1), located on the left side of the engine, from the bracket. Tighten the AIR injection
crossover pipe bushing nut to 12 Nm (108 inch lbs.).
19. Raise and support the vehicle.
20. Install the AIR injection crossover pipe (4) to the rubber hose connections (2).
21. Install the AIR injection crossover pipe clamps to the rubber hose connections.
22. Install the AIR injection crossover pipe bracket (6) nut to the generator bolt.
23. Counterhold the generator bolt with a wrench on the back side of the generator to install the AIR injection crossover pipe support bracket nut to
the generator bolt. Tighten the generator bolt to 40 Nm (30 ft. lbs.).
24. Install the splash shield.
25. Install the splash shield bolts. Tighten the splash shield bolts until fully seated. Do not strip the splash shield bolts.
26. Lower the vehicle.