Catera V6-3.0L VIN R (1997)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
Removal Procedure
Notice: Numbers in text in parenthesis correspond to numbered components in image.
1. Disconnect the wiring harness from the Camshaft Position (CMP) sensor (1).
2. Remove the A/C Low Pressure line bracket.
3. Remove the fastening bolt for the CMP sensor.
4. Remove the CMP sensor and the O-ring seal from the camshaft cover.
Installation Procedure
1. Thoroughly clean the mating surfaces of the CMP sensor (1) and the camshaft cover.
2. Install the CMP sensor with a new O-ring seal into the camshaft cover.
3. Install the fastening bolt for the CMP sensor.
4. Install the A/C Low Pressure line bracket.
5. Connect the wiring harness to the CMP sensor. Ensure the correct cable routing.