Catera V6-3.0L VIN R (1997)
11. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the air bag.
12. Twist together one connector wire lead to one deployment wire.
13. Inspect that the previous connection is secure.
Description
Description
14. Bend flat the twisted connection.
15. Secure and insulate the connection using electrical tape.
16. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
17. Connect the deployment harness to the inflatable restraint steering wheel module yellow 2-way connector.
18. Route the deployment harness out of the vehicle's driver side.
19. Install the inflatable restraint steering wheel module. Refer to Steering Wheel Inflator Module Replacement under Air Bag / Service and Repair.