Catera V6-3.0L VIN R (1997)
7. Remove oil cooler outlet pipe from transmission.
INSTALLATION PROCEDURE
1. Install the oil cooler outlet pipe to transmission.
2. Install the oil cooler outlet pipe fitting to transmission.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
-
Tighten the oil cooler outlet pipe fitting to 30 Nm (22 ft. lbs.).
3. Install the oil cooler inlet pipe to transmission.
4. Install the oil cooler pipe seals inlet fitting.
-
Tighten the oil cooler inlet pipe fitting to 25 Nm (18 ft. lbs.).
5. Install the retainer to oil cooler inlet and outlet pipes.
6. Install the center oil cooler inlet and outlet pipe hoses to oil cooler inlet and outlet pipes.
-
Connect the hoses to pipes.
-
Squeeze the clamps.
-
Slide the clamps into position.
7. Lower the vehicle.
8. Inspect and adjust the transmission fluid level.