Catera V6-3.0L VIN R (1997)
Center Support: Service and Repair
Center Bearing Replacement
REMOVAL PROCEDURE
^
Tool Required:
-
J 22912-01 Rear Pinion Bearing Remover
-
J 42099 Center Bearing Installer
1. Remove the propeller shaft.
2. Remove the propeller shaft slip yolk boot strap and remove the boot.
Important: Marking the propeller shaft must be performed to ensure correct spline alignment, as well as, retaining the production balance of the
propeller shaft assembly.
3. Mark the halves of the propeller shaft near the slip joint.
4. Separate the propeller shaft halves.