CTS V6-2.8L (2006)
Rear Door Exterior Handle: Service and Repair
Door Handle Replacement - Rear Outside
Removal Procedure
1. Place the window in the full up position.
2. Remove the door trim panel.
3. Pull back the water deflector far enough to access the outside door handle. Refer to Rear Side Door Water Deflector Replacement.
4. Disconnect the outside door handle latch rod (1) by opening the retainer (2) on the door latch.
5. Remove the outside door handle nuts through the access holes.
6. Remove the handle, with latch rod attached, by lifting up and out.
7. Remove the handle rod (1) from the door handle (2).
Installation Procedure
1. Install the door handle rod (1) to the outside door handle (2).
2. Install the door handle and rod into the door.