CTS V6-2.8L (2006)
26. Place the headliner upside down on a clean protected surface.
27. Disconnect the electrical connector (1) from the antenna module.
28. Disconnect the 2 coaxial cables (3,4).
29. Remove the antenna module from the bracket on the headliner.
IMPORTANT: Prior to removal, note the location of the ground strap for installation.
INSTALLATION PROCEDURE
1. Position the new headliner upside down, on a clean protected surface.
2. Transfer the antenna module (2) to the new headliner.
3. Attach the antenna module (2) to the bracket.
4. Connect the electrical connector (1).
5. Connect the 2 coaxial cables (3,4).
6. Ensure the antenna module ground strap is positioned properly to the headliner.
7. Install the rear dome lamp bezel (1) to the headliner.
8. Loosely install the fastener (3).
IMPORTANT: Ensure the bolt is placed through the antenna module ground strap.
9. Install the side assist handle retainers.
10. Install the assist handles and loosely install the fasteners in the integral retainer clips in order to hold the handles into position.
