CTS V6-2.8L (2006)
Important: Ensure that the locking tab and the flanges are in the fully engaged position.
6. Remove the J 22805-B (2) from the installed vacuum brake booster.
7. Reposition and connect the vacuum hose and check valve assembly to the booster.
8. Remove the surge tank inlet hose from the surge tank.
9. Install the coolant surge tank.
10. Install the surge tank inlet hose.
11. Install the air inlet grille panel.
12. Install the master cylinder to the vacuum brake booster.
13. If equipped with a clutch install the clutch master cylinder.
14. If equipped with a cross vehicle brace, install the cross vehicle brace.
15. Install the vacuum brake booster pushrod (3) to the brake pedal.
16. Install the vacuum brake booster push rod retaining clip (4) to the brake pedal.
17. Install the left closeout/insulator panel.
