CTS V6-2.8L (2006)
2. Install the mode actuator screws (2).
NOTE: Refer to Fastener Notice in Cations and Notices.
Tighten the screws to 1 N.m (9 lb in).
3. Connect the electrical connector to the actuator.
4. Install the I/P Carrier.
2. Install the mode actuator screws (2).
NOTE: Refer to Fastener Notice in Cations and Notices.
Tighten the screws to 1 N.m (9 lb in).
3. Connect the electrical connector to the actuator.
4. Install the I/P Carrier.