CTS V6-2.8L (2006)
Air Register: Service and Repair
Instrument Panel Air - Center
DEFLECTOR REPLACEMENT - INSTRUMENT PANEL AIR - CENTER
REMOVAL PROCEDURE
1. Pull out on the center I/P vent assembly in order to release the fasteners securing the vent to the I/P.
2. Disconnect the hazard switch electrical connector.
3. Remove the vent from the I/P.
INSTALLATION PROCEDURE
1. Connect the hazard switch connector.
2. Position hazard switch wire harness (1) in the harness retainers.
3. Push the wire service loop forward between the duct as the vent is positioned on the I/P.
4. Overlap the vent housing over the duct.
5. Position the vent into the I/P.
IMPORTANT: Ensure that the wire harness is not interfering with the moving parts of the vent.
6. Push the vent in to the I/P in order to seat the retainers.
