CTS V6-2.8L (2006)
Alarm Module: Service and Repair
THEFT DETERRENT MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling.
CAUTION: Refer to SIR Caution.
2. Remove the upper and lower trim covers.
3. Remove the lock cylinder.
4. Disconnect the connector from the theft deterrent control module.
5. If necessary, disconnect the connector from the ignition lock cylinder case.
6. Remove the theft deterrent control module from ignition lock cylinder case assembly.
INSTALLATION PROCEDURE
1. Install the theft deterrent control module onto the ignition lock cylinder case assembly.
2. Connect the connector to the theft deterrent control module.
CAUTION: Refer to SIR Inflator Module Coil Caution.
3. If necessary, connect the connector to the ignition lock cylinder case.
4. Install the lock cylinder.
5. Install the upper and lower trim covers.
6. Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling in Restraint Systems.
7. Program the theft deterrent system. Refer to Programming Theft Deterrent System Components.
8. Refer to Control Module References for programming and setup information. See: Testing and Inspection/Programming and Relearning
