CTS V6-2.8L (2006)
9. Connect the EBCM electrical connector (1) to the EBCM (3).
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
10. Rotate the EBCM connector tab (2) to the locked position.
11. Use the scan tool in order to clear the DTCs.
12. Perform the auto bleed procedure. Refer to ABS Automated Bleed Procedure.
13. If installing a new EBCM it is necessary to program the EBCM. Refer to Service Programming System (SPS).
14. Perform the System Check-Vehicle. Refer to Diagnostic System Check - Vehicle.
15. Recalibrate the brake pedal position sensor.
16. Refer to Control Module References for programming and setup information.